top of page
Masonry (built-in) Single Piece Hanger SPHS
Product Details
Brand Expamet BAT
Generic Ref
SPHS
Product Range
Builders Metalwork
Product Sub-range
Joist Hangers
Product Type
Masonry (built-in) Single Piece Hanger
European Standard/ETA
BS EN845-1:2013+A1:2016
Test Standard
BS EN 846-8:2000
Notified Body
Lucideon Ltd (NB 1289)
Material
Galvanized Mild Steel DX51D+Z600 to EN10346:2015
Coating/Finish/Colour
600g/m² Zinc Coating
Length 1/Projection
75mm Shoe, 75mm Flange
Material Gauge
2.0mm
Fire Rating
Euroclass A1
Fixing Type
Built in to masonry - No mechanical fixings required to wall. 3.75x30 square twisted nails to connect joist.
Installation requirement 1
Back of hanger must be tight against wall.
Installation requirement 2
Joists are to be cut square with a gap not exceeding 6mm from the rear of the hanger.
Installation requirement 3
A minimum 675mm of set masonry must be in place over support flange before loads are applied.
Installation requirement 4
Joist to be nailled through side gusset using 3.75x30mm square twisted nails.
Installation requirement 5
The underside of joists should be notched to provide a level surface for plasterboarding.
Packaging weight
0
Features/Benefits 1
Single piece, non welded construction
Features/Benefits 2
Non coaxial fixing holes
Features/Benefits 3
600g/m2 galvanized coating
Features/Benefits 4
Joists 150mm and above manufactured 10mm less to allow for notching/joist regularisation
Options 1
Joist widths: 38, 44,47,50, 63, 75, 89, 100, 125, 150mm
Options 2
Joist heights: 100-275mm in 25mm increments
Options 3
Return and Straddle options available
bottom of page